Suspect firmware problem? Can likely workaround by adminstratively setting the WLAN MAC using iw if you need the MAC address to be consistent. When the SBC is hard rebooted, it always defaults to the expected MAC address again. WLAN MAC changes often when soft rebooting the system.If you use it for audio, it will stutter in and out, for example. Bluetooth works, but performance is very “choppy”.You can download and install the kernel as follows: wget ĭpkg -i linux-image-5.9.8_5.9.8-1_b firmware-rockpix_20200907-1_b I was able to drive a 4k display with it over HDMI, connect to my wireless router and play YouTube videos, view SBC power consumption via reading of the onboard AXP288 PMIC, launch a virtual machine (VM), etc… So, it supports most, if not all, directly embedded hardware components of the device. Based on community feedback and testing, I may add more things where sensible and as time permits. In short, it is about as bleeding-edge as you can get and about as optimized as possible for this SBC. Is built from the latest stable Linux kernel source code to date (Linux 5.9.8).Is largely stripped down (tuned for embedded processors by removing server features like NUMA-awareness, only contains kernel modules for hardware components on this device, etc.).Is built with the newest version of GCC compiler (10.2.0).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |